Latest activity Postings Images About
-
-
The studs I ordered finally arrived, two days late but just ahead of the storm. As you can see, the 610-194’s most closely match the... -
1o1Proof replied to the thread What did you do to your JK today?.I had it powder coated, I just like the durability much better. The intensity bumper is what I have, but without the additional skid...
-
Replaced the AC/Heat actuator. Thanks Chris for the step by step instructions in the "How to" section. Also installed the Auxbeam 8 gang...
-
1o1Proof replied to the thread What Rigid lights are these?.I would contact rigid. Everything I have of theirs has a lifetime warranty…worth looking into.
-
I have a similar set up as 1o1Proof from Xprite. Super clean install and easy to add additional accessories.
-
1o1Proof replied to the thread Not enough heat.I would bet it’s your heater core, flush that dude out and see what happens.
-
1o1Proof replied to the thread How do I fix these wires?.Should be very easy to splice them back together. If there isn't enough slack in the harness, add a little wire to each and call it a...
-
1o1Proof replied to the thread What did you do to your JK today?.Also, finally got my winch reinstalled after the bumper upgrade. Yay me... Really like the new OuttaHand Fab bumper compared to the god...
-
-
1o1Proof replied to the thread What did you do to your JK today?.Finally got around to swapping out my tops. There was a thread comparing twill to standard, I didn't find it. Other than all the...
-
-
1o1Proof reacted to Dirty Dog's post in the thread Recommended product to restore black trim and fender flares with
Like.
While you've got them off, replace them with metal flares. Problem solved. :) -
1o1Proof reacted to Acxman's post in the thread Recommended product to restore black trim and fender flares with Like.
I haven’t found anything that lasts !
-
Me thinks the pod system either overhead or A pillar is most def the way to go . Expansion doesn’t get any easier as the under hood...
-
Got the engine pulled off the trailer and started to get it prepped for a proper cleaning... I ordered an engine stand from...
-
I'm building my 14B right now as well... I just ordered a set of the Dorman "loaded backing plates". They're quite nice and reasonably...
-
Little update on the axles, I’ve got both front and rear gears and lockers installed, tone rings installed on the hubs and rear rebuilt...
-
-
Loading…
-
Loading…
-
Loading…
