Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Wiring issue with center control panel
Reply to thread
Message
<blockquote data-quote="Ben_Amstutz" data-source="post: 443615" data-attributes="member: 22657"><p>Hello! I have a 2010 Jeep Wrangler Rubicon Unlimited and recently ran into an issue with the center control panel. I went to turn up the fan speed, and suddenly everything on the control panel went dark and the climate control fan stopped running. I later found out when I got home that my hazards, axle locks, diff disconnect, traction control, and 12v outlets also are not working. However, while trouble shooting, I found that if I shut my door harder than normal, everything boots back up. If I shut it hard again or change the fan speed, everything shuts down. I've checked all of the fused associated with the control panel, cleaned and tightened the associated ground points, and am still having the same issue. Any idea what else could be causing this?</p><p></p><p>Thanks for the help!</p><p>Ben</p></blockquote><p></p>
[QUOTE="Ben_Amstutz, post: 443615, member: 22657"] Hello! I have a 2010 Jeep Wrangler Rubicon Unlimited and recently ran into an issue with the center control panel. I went to turn up the fan speed, and suddenly everything on the control panel went dark and the climate control fan stopped running. I later found out when I got home that my hazards, axle locks, diff disconnect, traction control, and 12v outlets also are not working. However, while trouble shooting, I found that if I shut my door harder than normal, everything boots back up. If I shut it hard again or change the fan speed, everything shuts down. I've checked all of the fused associated with the control panel, cleaned and tightened the associated ground points, and am still having the same issue. Any idea what else could be causing this? Thanks for the help! Ben [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Wiring issue with center control panel
Top
Bottom