Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Turn signal issue?
Reply to thread
Message
<blockquote data-quote="Moab" data-source="post: 463678" data-attributes="member: 25366"><p>My turn signals seem to work two ways. The normal way. And kind of a "soft" lane changing way.</p><p></p><p>This is what happens both ways:</p><p></p><p><strong>The "soft" or temporary lane changing way.</strong></p><p></p><p>Where I'm driving straight and I move the lever. But the lever won't click. And it only blinks like 3 or 4 times. It's almost something you would use on the freeway changing lanes or something. Like maybe that's what it was designed for?</p><p></p><p>So driving straight, I move the lever, no click noise, and you get 3 or 4 blink's.</p><p></p><p><strong>The normal way:</strong></p><p></p><p>If my steering is a bit more into a steer. I move the lever and the turn signal clicks into a positive on. Stays there. And it will keep blinking until after the turn and I have straightened the steering again. Then it clicks off.</p><p></p><p>Is this how the Jeep turn signal works? Is it designed like this to give you a lane changing option or something?</p><p></p><p>2012 JKU btw.</p></blockquote><p></p>
[QUOTE="Moab, post: 463678, member: 25366"] My turn signals seem to work two ways. The normal way. And kind of a "soft" lane changing way. This is what happens both ways: [B]The "soft" or temporary lane changing way.[/B] Where I'm driving straight and I move the lever. But the lever won't click. And it only blinks like 3 or 4 times. It's almost something you would use on the freeway changing lanes or something. Like maybe that's what it was designed for? So driving straight, I move the lever, no click noise, and you get 3 or 4 blink's. [B]The normal way:[/B] If my steering is a bit more into a steer. I move the lever and the turn signal clicks into a positive on. Stays there. And it will keep blinking until after the turn and I have straightened the steering again. Then it clicks off. Is this how the Jeep turn signal works? Is it designed like this to give you a lane changing option or something? 2012 JKU btw. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Turn signal issue?
Top
Bottom