Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
General Discussions
Off-Topic
Trailer axle size
Reply to thread
Message
<blockquote data-quote="BLACKJKU" data-source="post: 438300" data-attributes="member: 18221"><p>I use a square tube and a square stub shaft and slide the shaft inside the tube. It has to be straight that way if you get the right size of square tube so the stub fits snug. My last trailer I set the stub on top of the tube and used some pieces of flat stock clamped on the sides to make sure it was straight. Then I had a 2" drop axle which made the trailer sit a little lower.</p></blockquote><p></p>
[QUOTE="BLACKJKU, post: 438300, member: 18221"] I use a square tube and a square stub shaft and slide the shaft inside the tube. It has to be straight that way if you get the right size of square tube so the stub fits snug. My last trailer I set the stub on top of the tube and used some pieces of flat stock clamped on the sides to make sure it was straight. Then I had a 2" drop axle which made the trailer sit a little lower. [/QUOTE]
Verification
Post reply
General Discussions
Off-Topic
Trailer axle size
Top
Bottom