Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Reviving a 2009 JK and experiencing wobble in passenger rear
Reply to thread
Message
<blockquote data-quote="Azulin" data-source="post: 449933" data-attributes="member: 23861"><p>I have a vibration, turned to wobble on my daughters Jeep jk.</p><p>Bought Jeep n looked like it had water damage. 9 months in, blew engine. I bought new engine block. Put in new engine. Installed OME 2.5 lift. Installed new suspension bushings front and rear. New steering stabilizer. Started driving Jeep around to break in engine. I’m at 200 miles and vibration turned constant mostly on rear passenger. Took the u-joint axle to get tested it is fine. Got new bearings pressed when I found a small leak. Checked engine mounts, transmission mounts, tomorrow I will open pumpkin and see if that is okay.</p><p>What else can it be? I read another thread similar to this but no conclusion.</p><p>If it is the gears for whatever reason, should I regear? If I do regear… do I do front and back? </p><p>Any advise or suggestions is appreciated.</p><p>I’m running out of ideas and money. Lol</p></blockquote><p></p>
[QUOTE="Azulin, post: 449933, member: 23861"] I have a vibration, turned to wobble on my daughters Jeep jk. Bought Jeep n looked like it had water damage. 9 months in, blew engine. I bought new engine block. Put in new engine. Installed OME 2.5 lift. Installed new suspension bushings front and rear. New steering stabilizer. Started driving Jeep around to break in engine. I’m at 200 miles and vibration turned constant mostly on rear passenger. Took the u-joint axle to get tested it is fine. Got new bearings pressed when I found a small leak. Checked engine mounts, transmission mounts, tomorrow I will open pumpkin and see if that is okay. What else can it be? I read another thread similar to this but no conclusion. If it is the gears for whatever reason, should I regear? If I do regear… do I do front and back? Any advise or suggestions is appreciated. I’m running out of ideas and money. Lol [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Reviving a 2009 JK and experiencing wobble in passenger rear
Top
Bottom