Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Rear Suspension Bushings
Reply to thread
Message
<blockquote data-quote="Danarch" data-source="post: 456822" data-attributes="member: 21093"><p>Never did it, I assume you are referring to the control arm bushings? If so I wouldn’t think to difficult. I would suggest spraying the bolts / nuts with a rust loosing product like PB Blaster or something the night before. Torquing the bolts to 125ft lb is rough.</p></blockquote><p></p>
[QUOTE="Danarch, post: 456822, member: 21093"] Never did it, I assume you are referring to the control arm bushings? If so I wouldn’t think to difficult. I would suggest spraying the bolts / nuts with a rust loosing product like PB Blaster or something the night before. Torquing the bolts to 125ft lb is rough. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Rear Suspension Bushings
Top
Bottom