Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Questions about running 37s on a Dana 30 front axle
Reply to thread
Message
<blockquote data-quote="DirtDauber" data-source="post: 449468" data-attributes="member: 23773"><p>Just my 2 cents.. For the type of offroad you're describing, I'd have some C gussets welded on and with the lower gears you have planned it'll most likely not give you any trouble. I will be going up from 35s soon to 37s BUT I like to wheel a little harder trails than you describe. My 30 has been geared along with a Detroit trutrac, trussed, gussets, and I run chromoly shafts with the larger 1350 Ujoints. Bottom line, all depends on the type of wheeling/driving you do and it sounds like you'll be just fine.</p></blockquote><p></p>
[QUOTE="DirtDauber, post: 449468, member: 23773"] Just my 2 cents.. For the type of offroad you're describing, I'd have some C gussets welded on and with the lower gears you have planned it'll most likely not give you any trouble. I will be going up from 35s soon to 37s BUT I like to wheel a little harder trails than you describe. My 30 has been geared along with a Detroit trutrac, trussed, gussets, and I run chromoly shafts with the larger 1350 Ujoints. Bottom line, all depends on the type of wheeling/driving you do and it sounds like you'll be just fine. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Questions about running 37s on a Dana 30 front axle
Top
Bottom