Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Question about LED's
Reply to thread
Message
<blockquote data-quote="WestSideKen" data-source="post: 459829" data-attributes="member: 25153"><p>I'm sure there are answers out there, but I'm having trouble finding them. </p><p>2011 Sport 2 door:</p><p>Replaced headlights with LED fixtures, and connected halo to running light. ALL GOOD</p><p>then, replaced front turn signals and side markers with LED fixtures . ALL GOOD</p><p>then, replaced back up with LED bulbs. ALL GOOD.</p><p>then replaced stop/turn with LED bulbs. Hyperflashing. </p><p>Put the original incandescents back in- still hyperflashing. </p><p>Swapped whole taillight assemblies (with built in resistors) out with LED's - still hyperflashing. </p><p>Doesn't hyperflash with 4 ways.</p><p>Could I have damaged the circuit board where the flasher assembly is?</p><p>Do I HAVE to ground both resistors on taillights? </p><p>Or will I have to put resistors on the front turn signals, also?</p><p></p><p>I know this is a lot, but any help is appreciated.</p></blockquote><p></p>
[QUOTE="WestSideKen, post: 459829, member: 25153"] I'm sure there are answers out there, but I'm having trouble finding them. 2011 Sport 2 door: Replaced headlights with LED fixtures, and connected halo to running light. ALL GOOD then, replaced front turn signals and side markers with LED fixtures . ALL GOOD then, replaced back up with LED bulbs. ALL GOOD. then replaced stop/turn with LED bulbs. Hyperflashing. Put the original incandescents back in- still hyperflashing. Swapped whole taillight assemblies (with built in resistors) out with LED's - still hyperflashing. Doesn't hyperflash with 4 ways. Could I have damaged the circuit board where the flasher assembly is? Do I HAVE to ground both resistors on taillights? Or will I have to put resistors on the front turn signals, also? I know this is a lot, but any help is appreciated. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Question about LED's
Top
Bottom