Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
P06DD code
Reply to thread
Message
<blockquote data-quote="dbsteff" data-source="post: 431946" data-attributes="member: 20360"><p>My 2012 JK, manuel, 120,000 miles, just threw the P06DD code. I’ve researched it and found numerous possibilities, everything from replacing the oil filter to replacing the oil pump. I did replace the oil pressure sensor last year. I’m wondering if anyone else had this issue and where to start? I’ve heard folks replacing everything from the pressure sensor to the oil pump, spending a lot of cash and not fixing the issue.</p><p></p><p>I wanted to check the oil pressure to rule out a bad pump but my JK doesn’t seem to have the oil pressure option on the EVIC. Is there a way to manually check the oil pressure? Everything appears to be working properly, the vehicle driving and sounding normal.</p><p></p><p>I also had the code PO128, (low coolant temp)thrown a couple weeks ago and I replaced the thermostat. Could these codes be related to a possible issue with the PCM?</p><p></p><p>Thank you for your time.</p></blockquote><p></p>
[QUOTE="dbsteff, post: 431946, member: 20360"] My 2012 JK, manuel, 120,000 miles, just threw the P06DD code. I’ve researched it and found numerous possibilities, everything from replacing the oil filter to replacing the oil pump. I did replace the oil pressure sensor last year. I’m wondering if anyone else had this issue and where to start? I’ve heard folks replacing everything from the pressure sensor to the oil pump, spending a lot of cash and not fixing the issue. I wanted to check the oil pressure to rule out a bad pump but my JK doesn’t seem to have the oil pressure option on the EVIC. Is there a way to manually check the oil pressure? Everything appears to be working properly, the vehicle driving and sounding normal. I also had the code PO128, (low coolant temp)thrown a couple weeks ago and I replaced the thermostat. Could these codes be related to a possible issue with the PCM? Thank you for your time. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
P06DD code
Top
Bottom