Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Off center ball joints...
Reply to thread
Message
<blockquote data-quote="macleanflood" data-source="post: 451312" data-attributes="member: 23653"><p>No idea on the original vehicle other than 2008 and Rubicon.</p><p></p><p>I ordered some C guessets from Barnes and I'm going to make a jig out of my Dana 30... guessing I will need to heat the top of the C and bend it in.</p><p></p><p>Also thinking about just replacing the inner C... getting a builder end for a 44...but I'm not sure if I could get it off the original tube.</p><p></p><p>Something tells me some heat, gussets and proper welding procedures will get me close enough.</p><p></p><p>-Mac</p></blockquote><p></p>
[QUOTE="macleanflood, post: 451312, member: 23653"] No idea on the original vehicle other than 2008 and Rubicon. I ordered some C guessets from Barnes and I'm going to make a jig out of my Dana 30... guessing I will need to heat the top of the C and bend it in. Also thinking about just replacing the inner C... getting a builder end for a 44...but I'm not sure if I could get it off the original tube. Something tells me some heat, gussets and proper welding procedures will get me close enough. -Mac [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Off center ball joints...
Top
Bottom