Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
O2 Sensor Ground Resistance
Reply to thread
Message
<blockquote data-quote="lehrjetmx" data-source="post: 441753" data-attributes="member: 22286"><p>Anybody know what the resistance on the ground wire should be from any O2 sensor Jeep side to the ground located on the bottom of the engine block? I would suppose it should be zero but I’m getting 667 ohms. Any one with their rig that has a few minutes would love feed back!!</p></blockquote><p></p>
[QUOTE="lehrjetmx, post: 441753, member: 22286"] Anybody know what the resistance on the ground wire should be from any O2 sensor Jeep side to the ground located on the bottom of the engine block? I would suppose it should be zero but I’m getting 667 ohms. Any one with their rig that has a few minutes would love feed back!! [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
O2 Sensor Ground Resistance
Top
Bottom