Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Looking for help on JKU Door Wiring
Reply to thread
Message
<blockquote data-quote="2007JK-KR" data-source="post: 464128" data-attributes="member: 24914"><p>My son is getting ready to purchase a 2009 JKU Sport that came from the factory with half doors so it never had any power windows. The current owner traded the half doors for four full doors with power windows and power locks. You would think Jeep would use the same wiring harness even if the model did not need those capabilities but instead, they had a 2-pin connector at each door that seems to have been for activating the dome light. </p><p></p><p>Has anyone done this conversion and if so, where did you source the male connectors that the door connectors plug into? The current owner installed the window switches in the center of the console and has the harness that plugs into the switches. This has a power and a ground and two wires for each switch to power window up or window down. So getting wires to the correct doors should not be two big of a problem but other than cutting them out of a junked JKU I have been unable to find them online. Thanks in advance for any help you can provide.</p></blockquote><p></p>
[QUOTE="2007JK-KR, post: 464128, member: 24914"] My son is getting ready to purchase a 2009 JKU Sport that came from the factory with half doors so it never had any power windows. The current owner traded the half doors for four full doors with power windows and power locks. You would think Jeep would use the same wiring harness even if the model did not need those capabilities but instead, they had a 2-pin connector at each door that seems to have been for activating the dome light. Has anyone done this conversion and if so, where did you source the male connectors that the door connectors plug into? The current owner installed the window switches in the center of the console and has the harness that plugs into the switches. This has a power and a ground and two wires for each switch to power window up or window down. So getting wires to the correct doors should not be two big of a problem but other than cutting them out of a junked JKU I have been unable to find them online. Thanks in advance for any help you can provide. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Looking for help on JKU Door Wiring
Top
Bottom