Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Lockers wont engage.
Reply to thread
Message
<blockquote data-quote="avionicstech40" data-source="post: 441062" data-attributes="member: 22165"><p>2010 rubicon 2 door....Recently I've been having problems with my e-lockers failing to engage in 4low. 4wd light on dash board doesn't indicate vehicle is in 4wd even though mechanically it is. Only indicates 4wd when transfercase is in neutral. No amount of driving will get lockers to engage and I assume it's because the computer doesn't recognize the jeep is in 4low electronically. I replaced the transfer case switch and it didn't help even though the old switch was bad and throwing a code. Diff fluid has been changed recently, so has transfer case fluid. This doesn't feel like a shimming issue and more like an electrical one. Wiring looks intact as well. Any help would be appreciated</p></blockquote><p></p>
[QUOTE="avionicstech40, post: 441062, member: 22165"] 2010 rubicon 2 door....Recently I've been having problems with my e-lockers failing to engage in 4low. 4wd light on dash board doesn't indicate vehicle is in 4wd even though mechanically it is. Only indicates 4wd when transfercase is in neutral. No amount of driving will get lockers to engage and I assume it's because the computer doesn't recognize the jeep is in 4low electronically. I replaced the transfer case switch and it didn't help even though the old switch was bad and throwing a code. Diff fluid has been changed recently, so has transfer case fluid. This doesn't feel like a shimming issue and more like an electrical one. Wiring looks intact as well. Any help would be appreciated [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Lockers wont engage.
Top
Bottom