Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Limp mode..
Reply to thread
Message
<blockquote data-quote="MarcSc1" data-source="post: 459851" data-attributes="member: 23524"><p>I found that if you use a magnetic pickup tool to remove the rocker arms and lifters (which I did bc a few dropped down in the head) and if you contact the tone wheel that the cam sensor reads, you can essentially erase the pickups that the cam sensor reads and then.....your cams are junk bc the tone wheel is pressed on at the factory.....so that's where I'm at. Wiring is the least of my worries. But good luck with your Jeep. It's always something!! Lol!!</p></blockquote><p></p>
[QUOTE="MarcSc1, post: 459851, member: 23524"] I found that if you use a magnetic pickup tool to remove the rocker arms and lifters (which I did bc a few dropped down in the head) and if you contact the tone wheel that the cam sensor reads, you can essentially erase the pickups that the cam sensor reads and then.....your cams are junk bc the tone wheel is pressed on at the factory.....so that's where I'm at. Wiring is the least of my worries. But good luck with your Jeep. It's always something!! Lol!! [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Limp mode..
Top
Bottom