LED headache

[Jim_Thorn]

Hello all. First time poster. 2008 JK.

Here's my tale:

I installed low cost Amazon LED tail lights + turn signals + halo headlamps. I left the side markers alone.

It all worked great for two weeks.

Then my turn signals went bad. The passenger side hyperflashes and the driver side's dead.

Hazard flashers still work fine. Everything else works fine. But no turn signals.

I disconnected the LED gear and re-installed the stock front turn lamps. So just the stock turn lamps and stock side markers connected.

Even with the LEDs pulled, the stock turn lamps wont work. Bulbs are brand-new.

My biggest worry is why the stock turn signals won't run even when the LED gear's disconnected.

Any thoughts? Fixes?

Thanks.

 

[BLACKJKU]

Did you check your flasher relay? Maybe swap it with the Hazard relay if they are the same.

 

[Jim_Thorn]

Did you check your flasher relay? Maybe swap it with the Hazard relay if they are the same.

I haven't checked the relay. Are there instructions for that?

I was told there's no flasher relay in the JK. It's computer controlled.

 

[BLACKJKU]

I just found this also https://www.hipoparts.com/taillights-marker-lights-not-flashing-or-rapid-flashing/

I would think the relay is in the fuse/relay box in the engine compartment.