Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
LED 3rd brake light wiring
Reply to thread
Message
<blockquote data-quote="Ballermaris" data-source="post: 429492" data-attributes="member: 18206"><p>I have the third light brake that came with the Wrangler, and the wire follows the wiring point through a rubber type of gasket on the right side of the Jeep. The wiring route is similar for the Alpine Backup camera that I have, which is nice since that 35" spare obstructs the rear. It comes on with the reverse lights but also can be switched on from the Alpine X409 Control Panel too. Once inside the body of the Jeep, follow the right side tail light wiring to the trailer connector.</p></blockquote><p></p>
[QUOTE="Ballermaris, post: 429492, member: 18206"] I have the third light brake that came with the Wrangler, and the wire follows the wiring point through a rubber type of gasket on the right side of the Jeep. The wiring route is similar for the Alpine Backup camera that I have, which is nice since that 35" spare obstructs the rear. It comes on with the reverse lights but also can be switched on from the Alpine X409 Control Panel too. Once inside the body of the Jeep, follow the right side tail light wiring to the trailer connector. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
LED 3rd brake light wiring
Top
Bottom