Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
JKU has no power from a dead stop
Reply to thread
Message
<blockquote data-quote="Islander" data-source="post: 427743" data-attributes="member: 19272"><p>if you clean your ground connections i would reccomend using a wire brush and not sand paper since sand paper uses aluminum oxide and will leave behind aluminum particles which when oxidized create higher resistance. It will work good for a short time then will slowly get worse. If you coat all the connections in dielectric grease that will slow down corrosion as well.</p></blockquote><p></p>
[QUOTE="Islander, post: 427743, member: 19272"] if you clean your ground connections i would reccomend using a wire brush and not sand paper since sand paper uses aluminum oxide and will leave behind aluminum particles which when oxidized create higher resistance. It will work good for a short time then will slowly get worse. If you coat all the connections in dielectric grease that will slow down corrosion as well. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
JKU has no power from a dead stop
Top
Bottom