Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
JK Pre-Start Oil Trick
Reply to thread
Message
<blockquote data-quote="WestCoastDan" data-source="post: 460084" data-attributes="member: 23120"><p>I get the idea behind it. Not unlike getting oil pressure to the heads on a freshly built motor by removing the coil wire from the distributor during the initial turn over.</p><p><strong>IF</strong> this trick would also magically remove the metal-to-metal contact that occurs it would make sense, <strong>BUT</strong>... all of the moving parts are still contacting each other <strong>BEFORE</strong> the oil gets there, so I have to ask... "Why bother"?</p></blockquote><p></p>
[QUOTE="WestCoastDan, post: 460084, member: 23120"] I get the idea behind it. Not unlike getting oil pressure to the heads on a freshly built motor by removing the coil wire from the distributor during the initial turn over. [B]IF[/B] this trick would also magically remove the metal-to-metal contact that occurs it would make sense, [B]BUT[/B]... all of the moving parts are still contacting each other [B]BEFORE[/B] the oil gets there, so I have to ask... "Why bother"? [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
JK Pre-Start Oil Trick
Top
Bottom