Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Is there a way in J-Scan to allow the transmission to go into overdrive while in 4WD low?
Reply to thread
Message
<blockquote data-quote="MacGuyver" data-source="post: 454645" data-attributes="member: 18877"><p>So playing around with this yesterday, when engaged does the dash light just blink or does it eventually go solid? My factory ones work pretty good and lock or release quickly with the factory switch, but with the app it just blinked forever, never going solid... blinked even after a vehicle shutdown for a bit.</p></blockquote><p></p>
[QUOTE="MacGuyver, post: 454645, member: 18877"] So playing around with this yesterday, when engaged does the dash light just blink or does it eventually go solid? My factory ones work pretty good and lock or release quickly with the factory switch, but with the app it just blinked forever, never going solid... blinked even after a vehicle shutdown for a bit. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Is there a way in J-Scan to allow the transmission to go into overdrive while in 4WD low?
Top
Bottom