Reviving this to see if there are any recommendations on the best way to use the factory wiring for aftermarket lamps that will not illuminate when connected to the factory harness.
I know the lights work as I have tested them individually from a stand alone battery.
I measure voltage at the factory connector w/ the fog light switch activated, but when I connect the aftermarket lights they will not illuminate.
I was thinking that adding a relay might work, but if the ECU is monitoring for current draw, I'm not convinced that the coil of the relay would be enough to 'trick' the system into working w/ my new lights.
Is this possibly something that Jscan can help resolve?
