Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Calendar
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Highbeams Always On after new headlights installed
Reply to thread
Message
<blockquote data-quote="MacGuyver" data-source="post: 435321" data-attributes="member: 18877"><p>sounds to me like you have a ground in the wrong place. </p><p></p><p>I have a pair like this and I had to do a bit of splicing etc to get the halo working, but the light itself was connected directly to the factory harness. </p><p>So that is the first thing you do is pull the light and disconnect the extra wires, hopefully you gave them quick disconnects. You can do waterproof ones if you are concerned, but honestly I doubt these lights would survive a river fording, and if you have deleted your inner fenders then some cheap disconnects are going to be the least of your problems. </p><p></p><p>After that, plug in only the harness. then test. It is entirely possible that the factory put the wires in the wrong places in the harness. You don't pay those prices for quality control. </p><p></p><p>Good luck, let us know.</p></blockquote><p></p>
[QUOTE="MacGuyver, post: 435321, member: 18877"] sounds to me like you have a ground in the wrong place. I have a pair like this and I had to do a bit of splicing etc to get the halo working, but the light itself was connected directly to the factory harness. So that is the first thing you do is pull the light and disconnect the extra wires, hopefully you gave them quick disconnects. You can do waterproof ones if you are concerned, but honestly I doubt these lights would survive a river fording, and if you have deleted your inner fenders then some cheap disconnects are going to be the least of your problems. After that, plug in only the harness. then test. It is entirely possible that the factory put the wires in the wrong places in the harness. You don't pay those prices for quality control. Good luck, let us know. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Highbeams Always On after new headlights installed
Top
Bottom