Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Heat blows hot on passenger's side but cold on driver's side
Reply to thread
Message
<blockquote data-quote="SouthernSass" data-source="post: 455622" data-attributes="member: 24762"><p>Ok, I'm having a similar issue, 2011 JK w/ 140k+ miles. A couple years ago my left driver side vent started slowly blowing colder while the heater was on, now it's progressed to the left center airvent. The vents also don't blow quite as hard, but not a supre noticeable amount. I've also noticed that switching between vents takes a few seconds. I can hear it thinking and kinda clicking a litte. Nothing when I turn the engine on and off though. I also don't leave my AC/Heat on when I turn my Jeep off. I found several websites that claim its the blender actuator on the driver's side, but now I'm seeing this. Sooooo, is this a heater flush, a blender actuator, or something else? I've looked at so much my brain feels like mush!</p></blockquote><p></p>
[QUOTE="SouthernSass, post: 455622, member: 24762"] Ok, I'm having a similar issue, 2011 JK w/ 140k+ miles. A couple years ago my left driver side vent started slowly blowing colder while the heater was on, now it's progressed to the left center airvent. The vents also don't blow quite as hard, but not a supre noticeable amount. I've also noticed that switching between vents takes a few seconds. I can hear it thinking and kinda clicking a litte. Nothing when I turn the engine on and off though. I also don't leave my AC/Heat on when I turn my Jeep off. I found several websites that claim its the blender actuator on the driver's side, but now I'm seeing this. Sooooo, is this a heater flush, a blender actuator, or something else? I've looked at so much my brain feels like mush! [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Heat blows hot on passenger's side but cold on driver's side
Top
Bottom