Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Ever wondered how much rust is under your sound / heat foam on the floorboard?
Reply to thread
Message
<blockquote data-quote="f22beaver" data-source="post: 452384" data-attributes="member: 24076"><p>You can actually buy a replacement floorboard, so it has the same ribbing and drain holes as OE. But as it will come to me it's much bigger than the space I need, so I'll cut it down to a size that is basically whatever point I find clean metal after I grind off paint and rust.</p><p></p><p>For attaching I'll use 3M's panel bond 8115. Some manufacturers use this stuff from the factory now. It is insanely strong and gives a strength equivalent to, arguably better, then welding. But I will have a lip where I have overlap, so if that was non-negotiable to somebody then they would have to weld.</p><p></p><p><a href="https://www.3m.com/3M/en_LB/p/d/v000056367/" target="_blank">https://www.3m.com/3M/en_LB/p/d/v000056367/</a></p></blockquote><p></p>
[QUOTE="f22beaver, post: 452384, member: 24076"] You can actually buy a replacement floorboard, so it has the same ribbing and drain holes as OE. But as it will come to me it's much bigger than the space I need, so I'll cut it down to a size that is basically whatever point I find clean metal after I grind off paint and rust. For attaching I'll use 3M's panel bond 8115. Some manufacturers use this stuff from the factory now. It is insanely strong and gives a strength equivalent to, arguably better, then welding. But I will have a lip where I have overlap, so if that was non-negotiable to somebody then they would have to weld. [URL]https://www.3m.com/3M/en_LB/p/d/v000056367/[/URL] [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Ever wondered how much rust is under your sound / heat foam on the floorboard?
Top
Bottom