Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Error codes and warning lights after installing Rough Country LED headlights
Reply to thread
Message
<blockquote data-quote="MacGuyver" data-source="post: 428088" data-attributes="member: 18877"><p>There should have been a canbus either integrated or as an additional piece that sits between the headlight and factory wiring. </p><p></p><p>LEDs operate differently than typical incandescent. They basically emit a signal that can cause interference. A canbus mitigates the interference. Higher end LEDs either don't emit this garbage signal or have mitigation circuits built in, I'm not quite sure, but on my work vehicle I had really nice LED flashers and when I wanted a second set for the front I took a cheaper route and I could hear them flash in the radio. </p><p></p><p>As far as the ABS etc stuff... um. Perhaps the same thing? Those are just plug and play right? How did you wire them?</p></blockquote><p></p>
[QUOTE="MacGuyver, post: 428088, member: 18877"] There should have been a canbus either integrated or as an additional piece that sits between the headlight and factory wiring. LEDs operate differently than typical incandescent. They basically emit a signal that can cause interference. A canbus mitigates the interference. Higher end LEDs either don't emit this garbage signal or have mitigation circuits built in, I'm not quite sure, but on my work vehicle I had really nice LED flashers and when I wanted a second set for the front I took a cheaper route and I could hear them flash in the radio. As far as the ABS etc stuff... um. Perhaps the same thing? Those are just plug and play right? How did you wire them? [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Error codes and warning lights after installing Rough Country LED headlights
Top
Bottom