Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Does anyone know of a good guide for pulling my 3.8 engine for a rebuild?
Reply to thread
Message
<blockquote data-quote="DHBirren2" data-source="post: 452284" data-attributes="member: 24199"><p>Pulling engines isn't that complicated if you take your time and get yourself the right equipment. I recently swapped my wife's Liberty engine. I found the best tool for that job wasn't the Harbor Freight/Pittsburgh engine hoist (shoulda gotten the larger one) or the load leveler. It was the ramps with hydraulic bottle jacks that raised the front end an extra 8 or 9 inches!</p></blockquote><p></p>
[QUOTE="DHBirren2, post: 452284, member: 24199"] Pulling engines isn't that complicated if you take your time and get yourself the right equipment. I recently swapped my wife's Liberty engine. I found the best tool for that job wasn't the Harbor Freight/Pittsburgh engine hoist (shoulda gotten the larger one) or the load leveler. It was the ramps with hydraulic bottle jacks that raised the front end an extra 8 or 9 inches! [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Does anyone know of a good guide for pulling my 3.8 engine for a rebuild?
Top
Bottom