Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Code 394
Reply to thread
Message
<blockquote data-quote="Rich Ealahan" data-source="post: 464386" data-attributes="member: 26178"><p>2014 jku. With 142000 miles. So changed the head and gasket due to a blown head gasket. That part went well. Car runs great until i get the code 394 and Jeep goes into limp mode. Get both engine light and stability control light. So far i have done both cam position sensors, crankshaft position sensor, spark plugs, checked all grounds. Look good. Checked wiring harness. Looks good. Can’t. Help but to think it is caused by the new head. Never had a prob like this before i changed the head. I read intermittent voltage loss. What could cause this? Sick of spending money and time on this thing. Oh yeah. While I’m doing all this i also replaced almost the whole front end.</p></blockquote><p></p>
[QUOTE="Rich Ealahan, post: 464386, member: 26178"] 2014 jku. With 142000 miles. So changed the head and gasket due to a blown head gasket. That part went well. Car runs great until i get the code 394 and Jeep goes into limp mode. Get both engine light and stability control light. So far i have done both cam position sensors, crankshaft position sensor, spark plugs, checked all grounds. Look good. Checked wiring harness. Looks good. Can’t. Help but to think it is caused by the new head. Never had a prob like this before i changed the head. I read intermittent voltage loss. What could cause this? Sick of spending money and time on this thing. Oh yeah. While I’m doing all this i also replaced almost the whole front end. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Code 394
Top
Bottom