Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Clutch issue
Reply to thread
Message
<blockquote data-quote="Jku2012" data-source="post: 420848" data-attributes="member: 17425"><p>The throw out bearing was on the correct side of the fork. The fork doesn’t move up and down on the slave side so I think it’s still on the ball pivot (ordered an inspection camera so I can look tomorrow). Do you know if the master cylinder needs to be pre bled?</p><p>Thanks for your help.</p></blockquote><p></p>
[QUOTE="Jku2012, post: 420848, member: 17425"] The throw out bearing was on the correct side of the fork. The fork doesn’t move up and down on the slave side so I think it’s still on the ball pivot (ordered an inspection camera so I can look tomorrow). Do you know if the master cylinder needs to be pre bled? Thanks for your help. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Clutch issue
Top
Bottom