Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Clutch / brake issue
Reply to thread
Message
<blockquote data-quote="Elle Toro" data-source="post: 430407" data-attributes="member: 20026"><p>I need some guidance. I have a manual transmission 2008 Jeep Wrangler. A few months ago I had a surprise high tide at the beach and ended up driving through high ocean water. A few weeks later my clutch started to go out. I took it to a shop and had the clutch replaced. Not a week out it wouldn't start. I was told it was the master and slave cylinders. I replaced those. Didn't even make it home from the shop and it wouldn't shift then would not even turn over. Apparently a bad slave cylinder and the clutch safety switch. Replaced again. Didn't make it home yet again and it's not longer shifting. Now It won't shift and the brake have seized up as well. Tried another shop and they want to start all over with the clutch again. Thoughts? I have tried several things, thought maybe the line wasn't bled properly but no that checked out. No leaks. I'm really not sure where to go from here. I hate the idea of starting all over with the clutch.</p></blockquote><p></p>
[QUOTE="Elle Toro, post: 430407, member: 20026"] I need some guidance. I have a manual transmission 2008 Jeep Wrangler. A few months ago I had a surprise high tide at the beach and ended up driving through high ocean water. A few weeks later my clutch started to go out. I took it to a shop and had the clutch replaced. Not a week out it wouldn't start. I was told it was the master and slave cylinders. I replaced those. Didn't even make it home from the shop and it wouldn't shift then would not even turn over. Apparently a bad slave cylinder and the clutch safety switch. Replaced again. Didn't make it home yet again and it's not longer shifting. Now It won't shift and the brake have seized up as well. Tried another shop and they want to start all over with the clutch again. Thoughts? I have tried several things, thought maybe the line wasn't bled properly but no that checked out. No leaks. I'm really not sure where to go from here. I hate the idea of starting all over with the clutch. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Clutch / brake issue
Top
Bottom