Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
General Discussions
Winches, Recovery Gear, & Communications
Clean GMRS antenna cable run from A-pillar into cowl area on 2007 to 2009 Jeep Wangler JK
Reply to thread
Message
<blockquote data-quote="Thomas R" data-source="post: 453716" data-attributes="member: 24423"><p>Hello and thanks Amok, the bracket I have attaches to the lower bolt on the A-Pillar . From there I have three choices 1. Into the door channel and chance getting it crimped on the door or 2. Run up the side of lower cowl to where the cowl is bolted then run it down inside cowl. 3. I'm thinking of running the cable horizontal the length of cowl (about 8 inches long) ,so that it's hidden in the seam created between the bottom of end cowl and the upper edge of drivers side fender with a litte help from some silicone then run it into cowl at hinged area of hood that will completely hide the antenna cable . I have a busy day tomorrow but I will try and get some pictures posted to help better with my explanation.....CHEERS !</p></blockquote><p></p>
[QUOTE="Thomas R, post: 453716, member: 24423"] Hello and thanks Amok, the bracket I have attaches to the lower bolt on the A-Pillar . From there I have three choices 1. Into the door channel and chance getting it crimped on the door or 2. Run up the side of lower cowl to where the cowl is bolted then run it down inside cowl. 3. I'm thinking of running the cable horizontal the length of cowl (about 8 inches long) ,so that it's hidden in the seam created between the bottom of end cowl and the upper edge of drivers side fender with a litte help from some silicone then run it into cowl at hinged area of hood that will completely hide the antenna cable . I have a busy day tomorrow but I will try and get some pictures posted to help better with my explanation.....CHEERS ! [/QUOTE]
Verification
Post reply
General Discussions
Winches, Recovery Gear, & Communications
Clean GMRS antenna cable run from A-pillar into cowl area on 2007 to 2009 Jeep Wangler JK
Top
Bottom