Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Calendar
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Can't remove track bar bolt, grrrr...
Reply to thread
Message
<blockquote data-quote="Frog lube" data-source="post: 441293" data-attributes="member: 22014"><p>I banged up my steering stabilizer and am trying to replace it. Since the one I banged up is a Teraflex it isn't the first time this has been replaced and no wonder as it sits below the axle tube. I bought a relocation bracket kit to move the stabilizer above the track bar but I cannot get the passenger side track bar bolt off. The nut it too close to the axle to get a socket on it (I think it is a flag-type nut anyway) so I am attacking it from the front. With my Milwaukee 3/8" impact turned all the way up it doesn't budge. I tried WD40 and no luck. Any ideas? Heat? I can go to DIY Auto and spend the $40 to put it on a lift and attack it with a 1/2" air impact but that's admitting defeat.</p></blockquote><p></p>
[QUOTE="Frog lube, post: 441293, member: 22014"] I banged up my steering stabilizer and am trying to replace it. Since the one I banged up is a Teraflex it isn't the first time this has been replaced and no wonder as it sits below the axle tube. I bought a relocation bracket kit to move the stabilizer above the track bar but I cannot get the passenger side track bar bolt off. The nut it too close to the axle to get a socket on it (I think it is a flag-type nut anyway) so I am attacking it from the front. With my Milwaukee 3/8" impact turned all the way up it doesn't budge. I tried WD40 and no luck. Any ideas? Heat? I can go to DIY Auto and spend the $40 to put it on a lift and attack it with a 1/2" air impact but that's admitting defeat. [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Can't remove track bar bolt, grrrr...
Top
Bottom