Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Brake pedal vibration
Reply to thread
Message
<blockquote data-quote="vaffanculo" data-source="post: 464650" data-attributes="member: 25989"><p>Hey sorry about your issue ok so that code 2204 can cause that issue with one or all sensors grabbing because it is showing a drop in voltage . First thing I would do is clear that code either with a scanner or just disconnect the negative battery terminal for a couple of minutes then reconnect . It's very possible that code not being cleared and stored in the ecu will case the problem just like when you get a oil change and if you dont clear the code it will continue to flash even though you changed the oil..good luck brother let us know</p></blockquote><p></p>
[QUOTE="vaffanculo, post: 464650, member: 25989"] Hey sorry about your issue ok so that code 2204 can cause that issue with one or all sensors grabbing because it is showing a drop in voltage . First thing I would do is clear that code either with a scanner or just disconnect the negative battery terminal for a couple of minutes then reconnect . It's very possible that code not being cleared and stored in the ecu will case the problem just like when you get a oil change and if you dont clear the code it will continue to flash even though you changed the oil..good luck brother let us know [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Brake pedal vibration
Top
Bottom