Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
Blinker and side marker light not working when headlights are on
Reply to thread
Message
<blockquote data-quote="docmopar" data-source="post: 457722" data-attributes="member: 24989"><p>I know this is a late post but I am going to post my finding in case it might help someone out. I have a 2012 jeep JKU and my front side marker lights stopped working. My front signal lights only worked when the parking lights were off and the front parking lights did not work. I checked the power to the sockets and there was power. Then I checked the resistance from the ground pin to ground and it was high. I found ground #112, the one behind the passenger headlight and in front of the air box is the ground for these lights. I cleaned it and reinstalled. No luck. Finally I cut into the electrical tape around the ground and fount that there are 5-16 gauge wires soldered into this lug along with the large wire. Those 5 wires were broken. I spliced an extension piece of wire on to them and put a new lug on them. Reconnected the grounds and all lights work beautifully. If you look at this ground quick it looks like 1 large wire but there are in fact 5 wires total. Hop this helps someone!</p></blockquote><p></p>
[QUOTE="docmopar, post: 457722, member: 24989"] I know this is a late post but I am going to post my finding in case it might help someone out. I have a 2012 jeep JKU and my front side marker lights stopped working. My front signal lights only worked when the parking lights were off and the front parking lights did not work. I checked the power to the sockets and there was power. Then I checked the resistance from the ground pin to ground and it was high. I found ground #112, the one behind the passenger headlight and in front of the air box is the ground for these lights. I cleaned it and reinstalled. No luck. Finally I cut into the electrical tape around the ground and fount that there are 5-16 gauge wires soldered into this lug along with the large wire. Those 5 wires were broken. I spliced an extension piece of wire on to them and put a new lug on them. Reconnected the grounds and all lights work beautifully. If you look at this ground quick it looks like 1 large wire but there are in fact 5 wires total. Hop this helps someone! [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
Blinker and side marker light not working when headlights are on
Top
Bottom