Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
2014 JKU stuck in limp mode
Reply to thread
Message
<blockquote data-quote="BLACKJKU" data-source="post: 436493" data-attributes="member: 18221"><p>Any electrical parts that are being installed are they OEM, it is known that the Jeeps are real picky about the parts that are put on them.</p><p></p><p>Low transmission fluid is known to cause problems.</p><p></p><p>Dirty, loose, broken ground wires and battery clamps can cause problems.</p><p></p><p>A weak battery can also cause problems.</p><p></p><p>After doing any electrical R&R was a reset done on the ECM so that it could relearn?</p></blockquote><p></p>
[QUOTE="BLACKJKU, post: 436493, member: 18221"] Any electrical parts that are being installed are they OEM, it is known that the Jeeps are real picky about the parts that are put on them. Low transmission fluid is known to cause problems. Dirty, loose, broken ground wires and battery clamps can cause problems. A weak battery can also cause problems. After doing any electrical R&R was a reset done on the ECM so that it could relearn? [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
2014 JKU stuck in limp mode
Top
Bottom