Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
2013 Wrangler JK EVAP issue and misc codes P0456
Reply to thread
Message
<blockquote data-quote="Nutsaboutcars" data-source="post: 463260" data-attributes="member: 25915"><p>Thanks BigAl. </p><p></p><p>So I checked all the lines. Cant find any isses. Replaced the rubber end up where purge valve connects to the engine. </p><p></p><p>Light went off. Drive around. So he takes it to the inspection place today. </p><p></p><p>Fail. </p><p></p><p>He has 3 ‘Not readys’ which failed him’</p><p></p><p>It has been 369 miles since he used a code scanner to reset. I figured all systems would be ready by now. Any ideas?</p><p></p><p>[ATTACH=full]126208[/ATTACH]</p></blockquote><p></p>
[QUOTE="Nutsaboutcars, post: 463260, member: 25915"] Thanks BigAl. So I checked all the lines. Cant find any isses. Replaced the rubber end up where purge valve connects to the engine. Light went off. Drive around. So he takes it to the inspection place today. Fail. He has 3 ‘Not readys’ which failed him’ It has been 369 miles since he used a code scanner to reset. I figured all systems would be ready by now. Any ideas? [ATTACH=full]126208[/ATTACH] [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
2013 Wrangler JK EVAP issue and misc codes P0456
Top
Bottom