Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
2007 JK Intermittent Start Issue
Reply to thread
Message
<blockquote data-quote="Eagle5" data-source="post: 438937" data-attributes="member: 21800"><p>I've got a 2007 JKU Rubicon with a 4.7L swapped engine. It will start fine if I put the key in the ignition and immediately start it. If I delay a bit (listen to the radio with the key in the run position) , it won't. If I kill it while shifting, it won't. I have to take the key out and let it sit for ~1 minute, then I can start as stated previously. I'm pretty good at electrical stuff, but I can't figure this one out. It looks like the PCM and the TIPM work together to get the starter engaged. The PCM grounds the relay, and the TIPM supplies 12v. It seems like the PCM tells the TIPM when the Clutch is pressed. I've tried and checked everything I can think of and can't figure out if its the PCM, the TIPM, or something else. It looks like the Clutch Pedal Position switch is okay. I have a scanner the lets me know that the TIPM is seeing the ignition key move to "start". I can start it directly by supplying 12v to the solenoid.</p><p></p><p>I would appreciate any help!</p></blockquote><p></p>
[QUOTE="Eagle5, post: 438937, member: 21800"] I've got a 2007 JKU Rubicon with a 4.7L swapped engine. It will start fine if I put the key in the ignition and immediately start it. If I delay a bit (listen to the radio with the key in the run position) , it won't. If I kill it while shifting, it won't. I have to take the key out and let it sit for ~1 minute, then I can start as stated previously. I'm pretty good at electrical stuff, but I can't figure this one out. It looks like the PCM and the TIPM work together to get the starter engaged. The PCM grounds the relay, and the TIPM supplies 12v. It seems like the PCM tells the TIPM when the Clutch is pressed. I've tried and checked everything I can think of and can't figure out if its the PCM, the TIPM, or something else. It looks like the Clutch Pedal Position switch is okay. I have a scanner the lets me know that the TIPM is seeing the ignition key move to "start". I can start it directly by supplying 12v to the solenoid. I would appreciate any help! [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
2007 JK Intermittent Start Issue
Top
Bottom