Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
15Rubicon no oil pressure..
Reply to thread
Message
<blockquote data-quote="15MONEYPIT" data-source="post: 446654" data-attributes="member: 23176"><p>I have a 15 wrangler with 153k miles and it lost oil pressure. I drove it about 5 miles to my shop with no knocks, ticks or slung rod. I replaced the oil filter/cooler housing and new sensors. I bought one off amazon with good reviews. Only negative comments were that the oil pressure sensor that came with it was bad on a few of the responses. So i went ahead and ordered a doorman sensor and swapped them out be i installed it. I just finished it up and cranked the jeep and guess what...NO OIL PRESSURE and a CEL. The code is p066d. The battery was unhooked for several days while waiting on parts and also I cleared the codes before starting, I even replaced the kn cartridge filter with a genuine mopar. Anyone have any suggestions before I tear it down again?</p></blockquote><p></p>
[QUOTE="15MONEYPIT, post: 446654, member: 23176"] I have a 15 wrangler with 153k miles and it lost oil pressure. I drove it about 5 miles to my shop with no knocks, ticks or slung rod. I replaced the oil filter/cooler housing and new sensors. I bought one off amazon with good reviews. Only negative comments were that the oil pressure sensor that came with it was bad on a few of the responses. So i went ahead and ordered a doorman sensor and swapped them out be i installed it. I just finished it up and cranked the jeep and guess what...NO OIL PRESSURE and a CEL. The code is p066d. The battery was unhooked for several days while waiting on parts and also I cleared the codes before starting, I even replaced the kn cartridge filter with a genuine mopar. Anyone have any suggestions before I tear it down again? [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
15Rubicon no oil pressure..
Top
Bottom