Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK
JK General Discussion
13 wrangler po522. Help!
Reply to thread
Message
<blockquote data-quote="Boyd6010" data-source="post: 449632" data-attributes="member: 23794"><p>My 13 wrangler threw the po522 code. Replaced the oil pressure switch plugs and coils. Got everything put back together. Jeep ran for 5 seconds. Shut off no start no crank. I have the code again and it will not go away I can't scan it out I disconnect the terminals that code still shows. I've checked voltage everywhere I can think to check im at a loss. Did I get a bad sensor or is it something I'm missing? Any help is greatly appreciated!</p></blockquote><p></p>
[QUOTE="Boyd6010, post: 449632, member: 23794"] My 13 wrangler threw the po522 code. Replaced the oil pressure switch plugs and coils. Got everything put back together. Jeep ran for 5 seconds. Shut off no start no crank. I have the code again and it will not go away I can't scan it out I disconnect the terminals that code still shows. I've checked voltage everywhere I can think to check im at a loss. Did I get a bad sensor or is it something I'm missing? Any help is greatly appreciated! [/QUOTE]
Verification
Post reply
Jeep Wrangler JK
JK General Discussion
13 wrangler po522. Help!
Top
Bottom