Forums
New posts
Search forums
Image search
Shop
Amazon Store
T-Shirts
Stickers
Members
Current visitors
Supporting Member Upgrade
Sponsors
About
Log in
Register
Search
Search titles only
By:
Search titles only
By:
New posts
Search forums
Image search
Search
Search titles only
By:
Search titles only
By:
Menu
Install the app
Install
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Jeep Wrangler JK Resources
JK How-to Guides
07+ Jeep Wrangler JK Intermittent Wiper Fix
Reply to thread
Message
<blockquote data-quote="WestCoastDan" data-source="post: 453663" data-attributes="member: 23120"><p>Well, I pulled the cowl, removed the motor/linkage assembly, & cleaned up the contacts inside the housing.</p><p>Still no go.</p><p>Wipers operate as soon as the switch is rotated from the off position, but only make a single swipe, then nothing.</p><p>Turn the switch to the next position, and I get another single swipe and then nothing.</p><p>Cycling up through the intermittent positions (which should decrease the time period between swipes) each yields the same result; a single swipe and then nothing.</p><p>If I increment the switch position past the intermittent positions to the "low", "med" of "high" positions, the wipers work as expected with consistent swipes.</p><p></p><p>Only the intermittent options seem to be impacted by this particular failure.</p><p></p><p>Any ideas on where to look?</p><p>Is there a separate control module somewhere that I can check out/test/replace?</p></blockquote><p></p>
[QUOTE="WestCoastDan, post: 453663, member: 23120"] Well, I pulled the cowl, removed the motor/linkage assembly, & cleaned up the contacts inside the housing. Still no go. Wipers operate as soon as the switch is rotated from the off position, but only make a single swipe, then nothing. Turn the switch to the next position, and I get another single swipe and then nothing. Cycling up through the intermittent positions (which should decrease the time period between swipes) each yields the same result; a single swipe and then nothing. If I increment the switch position past the intermittent positions to the "low", "med" of "high" positions, the wipers work as expected with consistent swipes. Only the intermittent options seem to be impacted by this particular failure. Any ideas on where to look? Is there a separate control module somewhere that I can check out/test/replace? [/QUOTE]
Verification
Post reply
Jeep Wrangler JK Resources
JK How-to Guides
07+ Jeep Wrangler JK Intermittent Wiper Fix
Top
Bottom