WSS's latest activity
-
Finally did the old crusty battery terminals on the JKU today. -
Got the Dorman Clockspring installed, as well as the new turn signal, and although it no longer clicks when turning the wheel, and my...
-
WSS replied to the thread Evap leak video (need confirmation).Did you have any other codes with the P0456?
-
WSS replied to the thread 120VAC inverters on the trail.I tested it with a 4.5" grinder and it worked well. The lifepo4 battery I used is a spare that was under 20% SOC but it did work fine...
-
WSS replied to the thread 120VAC inverters on the trail.Snuck in a few hours today. It is 95% done. All the wiring and wire pulling is done escept one end of the anderson connector. I ran out...
-
-
WSS replied to the thread Main and rod bearings on 2011 3.8.Oil samples: I know there are others that do the same, I use CAT SOS. I pre pay for a dozen and use as I need for our equipment. Single...
-
I switched my hard top to a soft top and love it! With the tradional soft top there are some downsides. In my opinion the plastic...
-
WSS replied to the thread Soft top downsides?.OP, Are you planning to do half doors as well? An option is a set of half doors and a bikini top, That is my favorite configuration. My...
-
WSS replied to the thread Front Mud Guard / Flap.If you are referring to the last pic (gray fender) in my post, that is adhesive leaching out with sand stuck to it. It seems very rust...
-
WSS replied to the thread Freedom top seals or leak fix.So you are aware of the salt spray in the air at night. It is an accumulative damage. I also believe the PO did not wheel it at all. I...
-
WSS replied to the thread Freedom top seals or leak fix.Thanks Anybodyhome! The tip about the tightening is probably what is happening. I more than "snugged" the rear bar bolts for sure and in...
-
So, here's what I learned a couple years ago.... 1. I don't tighten the rear sport bar screws much beyond snug. The tighter you make...
-
WSS reacted to Chris's post in the thread 2012 Jeep Wrangler Unlimited Sport Heater Not Working with
Like.
Since you've flushed the heater core and replaced the blend door actuator, there are a few other things you could check: Check the HVAC... -
Sorry to hear. I think I would be trying to replicate the leak with a hose to understand if it's occuring close to the point you...
-
WSS replied to the thread Freedom top seals or leak fix.The seals on the panels look fine, I did clean and condition the panel seal as well. There seems to be a seal "convergence" issue...
-
