Recent content by StaceyB

I have not. TBH, I was kinda nervous about driving with it off; not that I plan to take any hard or sharp turns if it is.

Thank you. 😀

Wasn’t being snarky about the long list … was just too lazy to type again. Multiple people have looked at the new front rotors and the old rear rotors and can find nothing visibly wrong with any of them (no grooves, warping, etc). So, I don’t know. Techs at the local Jeep dealership are...

If you go to the initial post, you’ll see the long list of everything we already tried. It has new rotors, calipers, brake pads, and wheel bearings on front and new wheel speed sensors all the way around.

No improvement after balance, rotate and align. My caster is at 2.5. The place I took it couldn’t adjust it more than that, but everything else is good. Had a 4x4 shop look at front and rear track bars, drag link and double check rear rotors and calipers. All good there. Still have the...

Even though it’s not been that long since my last rotate/balance/align, I’m going to do that again and hope for the best. I talked to a local tech and he thinks if that doesn’t work and the ECU won’t clear, I may need a new WCM and reprogramming. Let’s hope it’s not that. Thanks for everyone’s...

Measured. Diameter outside to outside was about 33.25”

Nope. Still happened with TPMS off. I was so optimistic. I’m about to surrender. Haven’t tried with ESC disabled.

No. 35 Nitto Terra Grapplers on Fuel rims. Appropriate tire size set in JScan.

This may actually be the right direction. A few months ago, I had a random week it didn't happen. It was right after a friend shut all my TMPS stuff off because I was running my tires low, and the light was on. I wanted to know my tire pressure, so I turned it back on. Some other adjustments...

Here is what was done a couple months before the issue started. I haven’t drawn any correlations, since there was a pretty good amount of time between this work and the vibration. The work was done by a reputable 4x4 shop I trust: New front and rear track bars New tie rods New ball joints New...

No. We just replaced all 4 with new ones. Issues happened before that and still do. No change. We were hoping that was the cause of the pedal vibration.

Pulled the PCM fuse for 2 minutes (yes, the correct one). Ran JScan. Cleared codes. Ran again. Still there. Tried 2 OBD modules. Same thing. Screenshot of the error code and screen shot of what I see when I go to restart all ECUs.

I don’t think it’s stuck. It goes away when I clear it. It just comes back on rescan. For good measure had my husband ground it in case I was doing something stupid. Code still there. I haven’t tried to “restart all ecus” in JScan yet. The B2204 error on JScan says “ecu configuration...

I can’t find any videos but I went ahead and tried it. My TMPS light isn’t on (just get the code when I run JScan). But, since the Jeep was in on-position, I held the trip reset button down until the engine light flashed 3 times. Shut it down for 30 minutes and restarted. Ran JScan. Code still...