Recent content by SRQ941

I changed the air control module in the throttle body. Now I can't get it to idol and back firing thru the throttle body.

I tried disconnecting battery overnight

Is it possible I could reset everything with a scanner

No pinch that I can find yet but I do have a wire with an eyelet that's in the cluster of wires whit the cam sensor. Does it connect to the side of the head?

Yes it's cables but it does it when there not connected and the butterfly does not open when I crank it. It just goes wide open

Yes

Everything is hooked up and it's still wide open. Any ideas on this

I got it together and all primed up. It started right up but wide open. I didn't have the breather on and the vacuum lines that connects to was unplugged. I'm hoping that's the reason. I disconnected the battery for the night. Gonna finish connecting things up in the morning.

Thank you for your time and help

I finally got all 6 pistons in and crank turning fine. I removed the Pistons and one of the bearings looked like a a brake rotor with no brake pads. It was a scar on the top of the crank journal that I didn't see. Lock down problem solved. I have one more question. How to spin the motor and get...

I guess now I will boil the Pistons and try to get the pins out and start over

Yes. I didn't no it mattered which way the rod went. The video tells me that the notches go opposite side of where the cam is. In other words noches to the driver's side and not the cam side.

Just watched a video and come to find out the notch on the bearing goes away from the cam. So it appears mine are backwards. Mine are on cam side.

I'm headed out now and check into it. I'll let you no in couple hours. Thanks again