Recent content by run2jeepn

New Winch line from BleepinJeep

Not with the Full load of the Jeep, but I did use it to drag a big 1100cc SeaDoo from the ground onto a trailer. Worked like it should. That was with the Red Winch rope. Haven't had time to test out the new Freedom line yet.

Planning to get my GateKeeper Knuckle mounts w/ lights done today or tomorrow. Also going to get my Lockers wired up into my switch panel. Plan is to run Power like normal, but run a Switch inside the Cab that disconnects the ground to them. So I have to flip that switch before the lockers...

I liked the idea of a 2 Speed. Along with the wireless and Synthetic Line. I got a screaming good deal, Plus they sent the wrong winch the first time. I got the XPV 13.5k first, They fixed it and shipped the XRS High Speed out ASAP and let me keep the XPV. Which worked out well, because Dads...

Out with the Old Tabor 9k winch. Installed my new X-Bull High Speed 13k. So far pretty cool. I like the Remote can be wireless and it has a magnet on it.

The Rubicon Axles are a direct bolt in. But the Rear 44 are not the same either. A Rubicon 44 has 32 splines and different length shafts. The Sport 44 has 30 splines and same length shafts. WMS is the same between the two.

Keep an eye on Marketplace. I found a set from a 2015 with 55k miles for 1900.

Yes they will bolt right up. Like mentioned above. Just make sure the gearing matches. Are you talking about the front or rear. Either way they bolt bolt up. Even thou the Non-Rubicon rear is a 44. The Rear Rubicon has stronger shafts. more splines. The Non-Rubicon is 30 splines and the Rubicon...

Fixed my Door strap that broke last week and installed the Soler Performance Throttle Controller.

I just put them on last week. I got the 37x12.5x17 from Walmart. They cost $248 a tire. Now I've been researching different tires for a while for my Jeep, about a year. I was set on the Geolander XMT till their prices almost doubled. Then I was leaning heavily on the Kenda MT2. They advertised...

I got more items in this week. Going to be installing a new Winch from XBull. My Current winch won't free spool anymore. So I worked a deal with XBull on their new Speed 13k winch. It's a cheap winch, but I'll see if it's a bargain deal or not. Time will tell. Also got a throttle controller...

No I haven't yet. There isn't much to it. Going to try and get it on This week or next. I have to install my GateKeeper mounts first. I will be doing a complete How to install for the EVAP Kit. So you'll know what to except.

Ya, I had 37s on before with 4.88s. I swapped axles out a while back to Rubcions and re-geared again to 5.38s this time.

No they came bare Aluminum.

Got the Tires mounted up last night.