Recent content by JustLostOne

All fixed. Cleaned the injectors, didn't solve the miss problem but no more lean condition. So next replaced plugs and coil and problem solved. Thanks for all the suggestions and help.

And also the throttle body. All done a little over a year ago.

Plugs, wires and coil pack is all I've done.

162k

So I've got 2 codes coming up, p0300 and p0174. I've checked plugs and changed wires cause 2 of them broke while getting them off. What else could be the problem? It was fine there day before and went out to go to work and it was running rough and then the codes came up.

There is a temperature sensor on the top front of the motor but I've replaced that also.

Fuel filter is in the fuel pump in the tank. Not sure that would make sense though since i can run the cooling fan for a few minutes and it will start fine.

It still did it during the winter. I've thought about wiring a switch to the cooling fan so that i could turn it on whenever I need to but also don't want to have it just on a switch.

Just since I've owned it. It's been doing it since sometime last summer.

I replaced the coil pack, wires and plugs and it was still doing it. Occasionally if I try too long to start it i get the CEL light with lean condition but again it only has the problem when it's been at temperature.

Yes. It fires and sputters out immediately.

I've tried that before and still the same problem.

So i have an issue where after i drive somewhere and my jeep get gets up to temperature, when i shut it off for a few minutes it won't start. It will fire up and immediately sputter out. It seems like once it's cooled down a bit it starts back up just fine. I've actually made up wires so that i...