Recent content by Justin_D

Thanks for your help, the paint is quite decent on the whole Jeep and I'm trying not to mess it up over a $30 set of lights. I was hoping there was another way that we could access the nut. Thanks again!

We will give it a shot, thanks for your help!

We were just trying to find a way to get it locked onto the tube (like the plastic connector) instead of a hose that could possibly slip off.

We ordered a new brake booster vacuum pump, we are trying to find the plastic 90-degree fitting.

When the fitting in the circle part of the pump was broken off in the 90-degree connecter. When we pulled the broken piece out of the connector, the inner part of the connector broke.

Trying to install brackets for lower windshield lights. The left side upper screw (pointed by screwdriver) is just spinning. is this just held in by a captive nut? if so, how do I access it?

Replacing the vacuum pump on my 13-jeep wrangler JK. The vacuum fitting on the pump broke off inside of the 90° elbow. We need to replace the elbow or the line and the Dealer wants $52 for the whole line and the fitting (Diagram 13) All parts stores say its a dealer only part. Anybody help?