Recent content by drevo1

We don't have repair kits in stock and need to wait up to 4 weeks. Therefore, I heated the shims with a gas burner and leveled with a hammer, they became flat. The thickness of the two shims together was 4.5mm with a conical shape, and when aligned the thickness became 3mm. I put everything back...

Recently became the owner of JK 2015 Sahara. I noticed that with the rear axle hanging, the wheels rotate very hard, and there are also extraneous sounds, as if the bearings had become square. I dismantled the rear axle, removed the differential, the differential was clamped, the gears rotated...

I monitored the value of the pressure sensor through diagnostics, and the value with the engine turned off reaches 65-70, when the pedal is pressed very hard, it is pressed 50% to the floor. When the engine is on, the pedal is pressed 100% to the floor with force, while the pressure value is...

I bought a car recently, so it was. I bled the brakes in the standard way, manual, starting with the rear passenger. Then I bled the ABS through diagnostics. I asked at the local Wrangler club and a couple of guys wrote that they had the same brake pedal behavior. So I'm confused - is it...

I found post with similar problem, where men have this issue on new JK, but he bought crd version https://www.wranglerforum.com/threads/jk-stock-new-brake-pedal-soft-to-the-floor.1475569/

Brake pedal goes 50% to the floor on parking, engine off, and brake pedal going 100% to the floor with some pressure when engine running(pressing on pedal not soft, and not hard). This is normal? I think brakes to soft, but wheels will block if I pressed pedal hard