Recent content by Brens07

  1. B

    Alshned headlight problem.

    Hello all, having a problem with what I believe are Alshned headlights. Passenger side is fine, drivers side is dim. If I swap headlights, same problem, so it must me in the wiring. I suspected a weak ground, so I made up jumper wires so I could ground it directly. Made no difference. Any...
  2. B

    Starter problem

    So is the knob glued, pressed, on with a clip?
  3. B

    Starter problem

    One video said to be sure anyone helping you stays back so you don't punch them in the face pulling the knob off
  4. B

    Starter problem

    Thanks Al! Yeah, my Haynes manual didn't have a lot to say about pulling the console. Figured I was gonna be on my own with that!😄 Thanks everybody
  5. B

    Starter problem

    Ok, so I replaced the shifter cable bushing today with the Dorman part. Was really hoping the bushing was at the shifter end. Maybe wishful thinking since the Jeep had been sitting out in the rain. Pulled it in, found the cable at the tranny, got the old bushing out and liked to never got the...
  6. B

    Starter problem

    I have noticed an oil leak, maybe the rear main. So far, putting it in neutral when it acts up has been successful so far. New shift bushings on the way. If it acts up again, I will sure look into your suggestions. Thank you!
  7. B

    Starter problem

    👍 Thank you!
  8. B

    Starter problem

    Looking back through this thread, I evidently missed some posts. Just want to say I appreciate everyone's help! Greg
  9. B

    Starter problem

    Wow, thanks BigAl! P/N and all!👍👍
  10. B

    Starter problem

    I'm sorry 😄
  11. B

    Starter problem

    I'm down 37 from you in Elwood
  12. B

    Starter problem

    I didn't notice you're in Huntington!
  13. B

    Starter problem

    18 years at KTP, 9 at Tipton
  14. B

    Starter problem

    I recently retired from Chrysler, but I only built the FWD tranny's.
  15. B

    Starter problem

    That's what I thought. If I may, can it be accessed by removing the shifter or does it have to be done underneath? And is that a dealer only part ?
See more
Top Bottom