Recent content by BlissfulJK

So does yours crank at all?

I did get mine sorted. Still not sure exactly what the problem was. I put in a new ignition switch, battery terminals, replaced a couple fuses, pulled the fuse box out and cleaned all terminals and reconnected. I had done a new starter at the beginning as well, because the old one was pretty...

I have not. Just looked that up now. I'll check and clean that as well. Thank you.

If it's cranking with jumping the relay, but won't crank with the ignition, what are the possibilities? I'll check those 3 fusible links, but I'm not sure what else could cause that. I've tried multiple relays.

I did that with all three keys, put in brand new batteries.

It comes on when I first turn on the key, then goes out and stays out.

I haven't tried that yet. I will try that this afternoon. I put the relay back in place and used the jumper and it cranks, but still won't fire. I thought it had to do with the key or relay, but no matter what I try, still no firing.

So nothing when I pop the clutch. It's in 4L. I checked and with the key on, I have power at pin 30 of the starter selinoid relay. I jumpered to pin 87 and it cranks. So what does that mean.

NP. I was like, wait, I tried that. haha I installed new terminals as well. I haven't tried popping the clutch with the key to crank position. I'll try that in a few minutes.

Good afternoon (at least in my part of the globe). I posted a question back in December of last year linked below... https://wranglerjkforum.net/threads/no-start-no-crank.31724/page-2#post-462734 So still sitting in my barn not starting. I had a couple surgery's so wasn't able to do much of...

I'm assuming since this thread is over two years old that you go your JK to start. What did it end up being?

True. I only meant that by jumping the relay I did get a good crank which made me lean away froa bad battery. And yes, I put the jumper pack directly on the battery terminals. I can try swapping in another battery as well, and I'll get this one tested.

I haven't had it tested, just with my voltmeter. I used a jumper pack as well, and when I jumped the relay leads it cranks over fine. I will also take the battery to a parts store tove it tested.

The date code is 2020. It hasn't given me any problems. I charged it overnigand put in iand tried again, nothing. I'd figure if it's a low battery I'd get a slow crank at first.

NP. OK, thanks. I'll check those.