Recent content by Billyum

I ment to say a 6 pin to connect to but no wire connector to connect up.

I check under the dash above the radio. Saw nothing but a connector just hanging. 2wire with 4 pin holes. Nothing to connect them to. Took the radio out but nothing their to connect them to. Seen only cable is radio cable. Their was a 6 on to connect to but no wire connector for that 6 pin...

Where is the component that calibrate and what does it look like

2011 3.8 wrangler. Navigation compass has reverse sensing North is South. South is North. Can't get the CAL. to light. Just goes to outside temp. Anyone know of any remedies?

Is uconnect needed for the compass to work?

Wrangler is 2011

Compass has reverse sensing. I push reset when stopped but the only thing it does is change temperature from F to C. I hit reset again and it jumps Bach from C to F. The temperature reading is set on the same step as the compass reading. Hope I explained this right. Thanks Bill