Latest activity Postings Attachments About

• • R

    Ryandou replied to the thread Clunking in front end when turning and shifting from fwd to reverse.

    No idea what kind of locker, po put it in there. I’m going into the shop tomorrow and will get more info. It’s the whole thing where I...

    Jan 16, 2023
  • R

    Ryandou replied to the thread Clunking in front end when turning and shifting from fwd to reverse.

    Finally got it in a shop, and they’re saying the locker on the rear is causing this behavior? Their solution is to swap that out with a...

    Jan 16, 2023
  • R

    Ryandou replied to the thread Clunking in front end when turning and shifting from fwd to reverse.

    Jan 7, 2023
  • R

    Ryandou replied to the thread Clunking in front end when turning and shifting from fwd to reverse.

    Thanks again for the replies, I think I might take a shot at it myself. I ordered the motor mounts and trans mount, might as well do all...

    Jan 7, 2023
  • R

    Ryandou replied to the thread Clunking in front end when turning and shifting from fwd to reverse.

    After doing a little research and looking at the set up is there a safe way to replace engine mounts myself? I’ve done it on a CJ7 but...

    Jan 6, 2023
  • R

    Ryandou reacted to BLACKJKU's post in the thread Clunking in front end when turning and shifting from fwd to reverse with Like.

    That's probably a bad trans mount or also possibly a bad engine mount causing the excess movement.

    Jan 1, 2023
  • R

    Ryandou reacted to JeepJeezy's post in the thread Clunking in front end when turning and shifting from fwd to reverse with Like.

    X2 on the Trans and or motor mounts.

    Jan 1, 2023
  • R

    Ryandou reacted to Dirty Dog's post in the thread Clunking in front end when turning and shifting from fwd to reverse with Like.

    X3

    Jan 1, 2023
  • R

    Ryandou replied to the thread Clunking in front end when turning and shifting from fwd to reverse.

    The front drive shaft has play in it in all directions where it extends/retracts (not sure on the terminology there). Also put that...

    Jan 1, 2023
  • R

    Ryandou replied to the thread Clunking in front end when turning and shifting from fwd to reverse.

    Thanks for the responses. Axle shaft u-joints have been replaced. I’ll check the drive shaft u-joint…am I just looking for play? Good...

    Dec 30, 2022
  • R

    Ryandou posted the thread Clunking in front end when turning and shifting from fwd to reverse in JK General Discussion.

    JK is clunking on the front end intermittently when turning sharp at slow speeds and when going from fwd to reverse and vice versa. I...

    Dec 29, 2022

  Show older items
• Loading…
• Loading…
• Loading…