pc1p's latest activity
-
I would always avoid spacers whenever possible but sometimes it’s the easiest solution for a clearance problem. I’d much rather do a... -
pc1p replied to the thread Need Wider Fenders.I'm sure you're familiar, but let's do a quick review for those not familiar with the math... When, T = F x d (I'll stick with simple...
-
Ok I'll bite, since I've learned you never say something without substantiation. Is it not possible to get sufficient clamp load on a...
-
pc1p replied to the thread Need Wider Fenders.Ehh, I wouldn't go so far as to say "only"... While buying from a trusted brand and following good maintenance/install practices will...
-
I'd get rid of the spacers instead. They're inherently unsafe anyway.
-
I hit a few local spots in new england but nothing serious. I’m hoping to hit windrock around gsmji with the bleepin jeep crew and a few...
-
Most recent upgrades included a 1/2” leveling puck up front to remove the factory rake as well as iron rock offroads trail tamer hydro...
-
Took her out a few times this last year and started gathering parts for the next phase of the build which will be a 10” rear axle...
-
I don’t really disagree. I just don’t like putting in parts and hoping for the best. Give me the ability to dial everything in. I’m...
-
pc1p replied to the thread Caster question.It certainly can argued for or against validly... For me it depends on the rig. On a JKU, where the arm geometry is pretty decent and...
-
Personally, I would not do a lift without adjustable lower control arms. Even a 2 inch lift. Although I do agree you can. Just in my...
-
pc1p replied to the thread 2008 JKU "Argenta" Build Thread (plus a 2010 Islander side project).I went back and cleaned up all the wiring for the transmission and shifter. I ended up using a small aluminum plate under the glove box...
-
-
pc1p replied to the thread Caster question.No - your caster angle is the difference between true 0° and imaginary line that runs through your balljoints centerline when viewed...
-
-
pc1p replied to the thread Caster question.Caster is measured against true vertical. Assuming your angle finder was zero'ed out appropriately, it's very likely the cause of your...
-
-
pc1p replied to the thread 2008 JKU "Argenta" Build Thread (plus a 2010 Islander side project).Some good news - I was able to test crank (not start, just crank!) the engine! I got the C3 connector (the body harness portion of...
-
